Product service
[list:title][list:title]
STZ3 Flush Diaphragm Pressure Transmitters
category：Pressure Transmitters
GO BACK
Print current Favorite
This product contains the following details
Description
Features
Technical Data
Dimension


STZ3-1 Flush Diaphragm
（1.6～150MPa）		STZ3-2 Flush Diaphragm
（1.6～150MPa）		STZ3-3 准齐平膜
 （适用于小量程）
无腔压力变送器无腔压力变送器
准齐平膜压力变送器

 

 
Installation schematic (for reference)

thread the front seal
 
Installation Suggestion：
⑴ This product can use M20 x 1.5 interface directly installed on the pipeline (or the container wall), thread the front-end when installation should add copper pad or nylon washer for front end face seal. And, without cavity pressure transmitter thread front end flat membrane sensing head can not touch installation part of the front and side wall. Otherwise it will affect the performance of the pressure transmitter.
⑵ Should be used when measuring high temperature medium, pressure pipe or other cooling device, the temperature dropped to pressure transmitter using temperature range.
⑶ When the outdoor installation, should try to put the transmitter in ventilated, dry place, avoid bright lights direct illuminate and wet, otherwise will make the performance variation or malfunction.
⑷ If the transmitter output or output exception found after installation, please check:
   ① Electrical connections are accurate, whether the firm；
   ② Whether the power supply voltage is too low and the load resistance is too large.